hotrod84
09-30-2009, 10:05 AM
i know this is not a s10. i've rebuilt the front end out of my 85 chevy 4x4. frist when i pulled the lock in/out hubs out of the rotors and the spindle nuts. i had to beat the rotors of the spindle. now i have assembled the rotors with the same bearing(cleaned up good, no damage)when i try to slide the rotor on the spindle it will stop prior to the inner bearing going all the way on. i'm goona try to sand the spot where the inner bearing goes. if this does not fix it i think the spindle is bad.