fenderwells and drop spindles??

[Mailman]

I was wondering if anyone out there could tell me if i can run hedman hustler fenderwell headers with 2" drop spindles? the foot notes on sumitt says no drop spindles. Wanting to know before i spend $650 for nothing. thanks all. read the last #232
Make CHEVROLET
Model S10
Beginning Year 1982
Ending Year 2004
Engine Swap Yes
Engine Type V8
Engine Size 5.7L/350
Engine Family Chevy small block Gen I
Drivetrain 2WD
Power Steering Yes
Power Brakes (application) Yes
Air Conditioning No
Standard Transmission Column Shift No
Standard Transmission Floor Shift Yes
Automatic Transmission Column Shift Yes
Automatic Transmission Floor Shift Yes
Footnotes 45 - Not legal for sale or use in California on pollution-controlled motor vehicles.
52 - All tubes fenderwell.
68 - Racecar header, slip-on collector. For adjustable, see accessory listing.
69 - Flange may need to be cut between ports to install. Do not cut between twin ports.
80 - Headers come with sub-flange.
97 - Must use Trans-Dapt TRD-9926 conversion motor mounts with 2.8L frame mounts.
105 - Fits new angle plug heads with raised exhaust ports.
RH - RACING HEDDER! Not legal for use on pollution controlled vehicles.
232 - No drop spindles.

[farond21]

I am running fenderwells and drop spindles without issue...

[406shark]

I am running fenderwells and drop spindles without issue...

x2


Jeff

[Mailman]

I thought do. Just making sure. Thanks guys.

[85ss]

I am running fenderwells and drop spindles without issue...

X3...

[phillip wigington]

the fenderwell exit is designed around a small tire upfront! if you run a 7 or 8 inch wheel in the front you will not have very good turning radius because of the tubes hitting the tires! because of the changing of the wheels instabt center being raised on the spindles!!!! with the drop spindles and dropped srings it has more turning radius with the narrow 3.5 or 4 inch wheel. i know because i work at HEDMAN HUSLER HEDDERS and i have a s10 blazer as well! hope this helps!!!!

[Mailman]

the fenderwell exit is designed around a small tire upfront! if you run a 7 or 8 inch wheel in the front you will not have very good turning radius because of the tubes hitting the tires! because of the changing of the wheels instabt center being raised on the spindles!!!! with the drop spindles and dropped srings it has more turning radius with the narrow 3.5 or 4 inch wheel. i know because i work at HEDMAN HUSLER HEDDERS and i have a s10 blazer as well! hope this helps!!!!


Thanks Philip. You the man...