jig bushings

[slow89s10]

Diabolical, have you had any luck finding matrial to make them? If I can get you some what do you need to make them? I do work for a company that uses alot of Aluminume and if I remeber it 6061 so please let me know

[Diabolical]

See what you have for stock and let me know.. I need that link again too
This will take no time to do.. Just finding the time.. After this weekend..
I am only working 5/10hr days a week..
So I am going to be able to work on projects again :drummer:

Mike

[slow89s10]

I hope these pic will help and hope the info is to your liken.

5 Housing End Alignment Sleeve (Lrg Ford/Mopar)
For 3.150” and 2.875” O.D. axle bearings (stock Mopar ends). Also has shoulder for locating 3” x .250 tubes and thier is also the dimsons for the other end size

Housing End Alignment Sleeve (Lrg Ford/Sm Ford)
For 3.150” and 2.835” O.D. axle bearings (Mustang ends). Also has shoulder for locating 3” x .250 tubes

6 The ring set allow you to expand the range of housings that can be narrowed some stock 9" Ford and 8.8 Ford cases have a 3.062" outside diameter ring set

7 The ring set allow you to expand the range of housings that can be narrowed some aftermarket 9" Ford cases requires a 3.250” outside diameter ring set

8
The ring set allow you to expand the range of housings that can be narrowed some 9" Ford (slimline bearings) and 10 Bolt Chevrolet require a 2.891” outside diameter ring set

[slow89s10]

if you need any more info let me know. I didn't put in the I.D. of the bushings because that way you can put your own in but the company I got the info from uses 2" dia harden steel bar you need to let me know how much matriel you will need like the thickness and over all size

[mytmouz]

I covet those...:ihih:

[Diabolical]

Excellent!!
I will let you know.. 2" seems big.. especially if most of the OD is 3" to 3-1/4"
I am getting ready to narrow a 9" for "Low Buck" so this will have to happen soon! :)

[slow89s10]

yes it will, and plus will have to take some time for shipping to

[slow89s10]

Mike I talks to some one at work about the alum and he told me to find out how much that will be needed,and I'll get a discount on it.

[Diabolical]

I will call you later.. check your PM's :)
I need to see what I did to the pic settings.. I thought I set it up so they could be as large as anyone wanted.. Something is up