Broken Speedometer Gear

[smsmith36]

A while back my speedometer cable got too close to the exhaust and melted the plastic and snapped the cable. I replaced the cable and it didn't work. Took the drive shaft off and removed the tail shaft housing. It's a TH 350. Found this.

http://i85.photobucket.com/albums/k42/smsmith36/1989%20S-10%20%20%20V-8/P6064932.jpg

This clip that holds the gear was laying in the bottom.

http://i85.photobucket.com/albums/k42/smsmith36/1989%20S-10%20%20%20V-8/P6064934.jpg

I need to know which way the clip goes in. Does it go this way so the gear can't slide toward the drive shaft?

http://i85.photobucket.com/albums/k42/smsmith36/1989%20S-10%20%20%20V-8/P6064936.jpg

Or does it go this way so the gear can't slide toward the front of the trans?

http://i85.photobucket.com/albums/k42/smsmith36/1989%20S-10%20%20%20V-8/P6064935.jpg