AN plumbing

[85cam]

8an hoses be enough to support 700HP?
I hope so because I have already bought it all! LOL
Pics to come as sooon as last piece comes in, the line from fuel cell to pump.
Using braided line from cell to pump the hard line from pump to regulator set up.
then flex an line from regulators to carb and N2O plate.

Think this will suffice? Using a holley black, hope it has enough! LOL

[dand355]

hmm sounds good let me see -8 is 7/16 id and the holley pumps out 140 gal hr . a -10 9/16 id would be nice to a y block than -8 to the reg and -6 to the carb and -6 to nos plate you got a big boy 800 hp lot of fuel .. -8 will work good and you have it . i don't have that much hp but that is how i ran my fuel, and with a return line of -6 but my peewe doesn't need that much fuel also. you got alot of hp going to be a fun ride

[dand355]

i used that size of hose becuase my pumps had that size fittings check out your pump it'll tell you what size is recomended

[85cam]

no I think 8an is 8/16 that is how I remember it at least
Someone help us out here

but anyway I got 6 running to the plate, the pump had 3/8 in and out but I have converted these to 8an via the convertor pieces
If the pump cant keep up with both i can always run a second pump to the plate, and then later on if needed I could always go fogger with it and the plate

[434 smallblock]

no I think 8an is 8/16 that is how I remember it at least
Someone help us out here

but anyway I got 6 running to the plate, the pump had 3/8 in and out but I have converted these to 8an via the convertor pieces
If the pump cant keep up with both i can always run a second pump to the plate, and then later on if needed I could always go fogger with it and the plate

I would use the plate on minimul shot but would add a second pump. the black ans #8 with the 6 from the regs will be fine .I ran a blue for motor and a blue for nos it did fine ,make sure you use relays. I went with the magna fuel500

[mytmouz]

8 will be fine...

[Diabolical]

http://www.s10racer.com/board/showthread.php?t=442