tubular control arms

[quicks10]

Seeing if anyone is interested in these before I send them back..

A NEW pair of right sides 8 inches. speedway uppers

These were just bolted on.and took right off...

Ill be sending these back next week.

[Prostreet1]

Hey quick...why are sending them back? I have been contemplating getting a set...

[quicks10]

Hey quick...why are sending them back? I have been contemplating getting a set...

I needed the left sides...

[Prostreet1]

I needed the left sides...

Ya...I was under the understanding that you had to have 2 of the one side...is it the lefts?

[quicks10]

yes you do need one side..some say right and some say left..I was told the right side so that's what I got.. best way to know is measure them..I didn't do that till after..

[Prostreet1]

yes you do need one side..some say right and some say left..I was told the right side so that's what I got.. best way to know is measure them..I didn't do that till after..

Not wanting to embarress myself quick....but where do you measure?...or should I say what do you measure. I was told to just buy 2 and flip the one over??

[Prostreet1]

I mean I know I measure the A-arm...but what am I measuring...the space between the bolts that hold it? on center to on center?

[quicks10]

You do flip one over... This is how I measured mine ..

From the crossbar to the center of the ball joint..

[littlewickeds10]

just curious but why do you need the left sides? Everypost I have ever seen about these control arms, everyone says to get the right side

[quicks10]

it was because i had negative camber without any of the shims on there..

when i drop my engine in it would be way worse with weight on the front..... and all the post i read too said rights also..

[quicks10]

Sold!!!!